Contents
Input Select
Set the audio input mode and decode mode of each input source.
The input modes available for selection may vary depending on the input
source.
2 Input Mode
Set the audio input modes for the different input sources.
It is normally recommended to set the audio input mode to "Auto".
Auto (Default) : Automatically detect input signal and perform playback.
HDMI : Play only signals from HDMI input.
Digital : Play only signals from digital input.
Analog : Play only signals from analog input.
7.1CH IN : Only signals input from the 7.1CH IN connector will be
played back.
%
• When digital signals are properly input, the
~
If the
indicator does not light, check "Input Assign" (vpage 154) and
the connections.
• If "HDMI Control" is set to "On" and a TV compatible with the ARC is
connected via the HDMI MONITOR connectors, the input mode whose input
source is "TV AUDIO" is fixed to ARC.
• The sound mode cannot be set if the input mode is set to "7.1CH IN".
Front panel
Display
Connections
Playback
~
indicator lights on the display.
Rear panel
Settings
2 Decode Mode
Set the audio decode mode for input source.
Auto (Default) : Detect type of digital input signal and decode and play
automatically.
PCM : Decode and play only PCM input signals.
DTS : Decode and play only DTS input signals.
%
• This item can be set for input sources for which "DIGITAL" is assigned at
"Input Assign" (vpage 154).
• Normally set this mode to "Auto". It is recommended to set "PCM" or "DTS"
when audio is missing at the beginning or a noise occurs. Set "PCM" and
"DTS" when inputting the corresponding input signal.
157
Remote
Tips
Appendix
Index