10.
Disconnect the power connector cable (2) from the system board.
11.
Remove the four Phillips PM2.5×6.0 screws (1) that secure the system board to
the base enclosure.
12.
Lift the right side of the system board (2) until it rests at an angle.
13.
Remove the system board (3) by sliding it up and to the right at angle.
Reverse this procedure to install the system board.
Fan/heat sink assembly
NOTE:
The fan/heat sink assembly spare part kit includes replacement thermal material.
Description
For use only on computer models equipped with an AMD processor and a graphics subsystem
with discrete memory
For use only on computer models equipped with an AMD processor and a graphics subsystem
with UMA memory
76
Chapter 4 Removal and replacement procedures
Spare part number
682179-001
682178-001