To Install Pointing Stick Support - HP F2974KT - OmniBook 500 - PIII 700 MHz Manual

Note
Note
11. Select "Intel Ultra ATA Controller" and then click "OK" to install the driver.
If the driver was previously installed on the system, a dialog box will appear stating that
the driver for the "Intel PIIX PCI Bus Master IDE controller" or "Intel Ultra ATA
Controller" is already on the system. If this occurs, select "New" to install the new
driver.
12. When prompted, reboot the system as directed in order for the changes to take effect.
13. You may get a Services Control Manager dialog box, click OK. Login, go to
START>SETTINGS>CONTROL PANEL double-click on the Devices icon.
14. Find device Atdisk. Click the Startup button. select Disable, click OK.
15. When the Devices dialog box asks if "...you want to make the changes?", click "Yes".
Close the Devices window. Close Control Panel.
After installation, the INTELATA.SYS file is stored in the <Windows NT
directory>\SYSTEM32\DRIVERS directory.

To install pointing stick support

If you have installed retail Windows NT you need to install the pointing stick drivers.
The pointing stick drivers is in the \HP\DRIVERS\NT4\TRACKPNT subdirectory.
To install or upgrade the pointing stick drivers:
1. Start Windows NT 4.0.
2. On the Taskbar, click the Start button.
3. Select Settings, Control Panel.
4. Double-click the Mouse icon.
5. Select the General tab at the top of the Mouse Properties panel.
6. Click "Change".
7. Click "Have Disk".
8. Enter the full path of the \HP\DRIVERS\NT4\TRACKPNT directory.
9. Click OK, to install from disk.
10. Select IBM PS/2 TrackPoint from the list.
11. Click OK.
Using Windows NT 4.0
Installing Windows NT 4.0
Corporate Evaluator's Guide 131