System Settings - Timers - Dell C3765dnf Color Laser Printer User Manual

*2
RAM Disk
Fax Server Address Book
E-mail Server Address Book On
Apply New Settings
Restart printer to apply new settings
*1
When you specify 1 minute for Sleep, the printer enters power saver mode 1 minute after it finishes a job. This uses much less energy,
but requires more warm-up time for the printer. Specify 1 minute if your printer shares an electrical circuit with room lighting and you
notice lights flickering.
Select a high value if your printer is in constant use. Under most circumstances, this keeps the printer ready to operate with minimum
warm-up time.
Select a value between 1 and 60 minutes for the power saver mode if you want a balance between energy consumption and a shorter
warm-up period.
The printer automatically returns to the standby mode from the power saver mode when it receives data from the computer. You can
also return the printer to the standby mode by pressing the
*2
This item is not available when the optional hard disk is installed.
*3
When the optional 512MB memory module is installed.

System Settings - Timers

Purpose:
To configure the auto clear time and time-out time.
Values:
Auto Reset
Fault Time-out
Job Time-out
Apply New Settings
Restart printer to apply new settings
Off
Available Range: 50–100MBytes
Available Range: 50–600MBytes
On
Off
Off
45 seconds
1 minute
2 minutes
3 minutes
4 minutes
0
Available Range: 3–300 seconds
0
Available Range: 5–300 seconds
Does not allocate RAM for the disk file system. Secure
Print, Private Mail Box Print, Public Mail Box Print, and
Proof Print jobs will abort and be recorded to the job log.
Allocates RAM for the disk file system automatically.
*3
(in 50 MB increments)
Enables the server address book for fax numbers.
Disables the server address book for fax numbers.
Enables the server address book for e-mail addresses.
Disables the server address book for e-mail addresses.
After you change the settings, click this button to apply
the changes.
Click this button to apply the changes.
(Power Saver) button on the operator panel.
Sets the amount of time before the printer automatically
resets the settings on the operator panel to the defaults
when no additional settings are made.
Sets the amount of time the printer waits before canceling
a job when the job stops abnormally.
Sets the amount of time the printer waits for additional
data from the computer before it cancels the job.
After you change the settings, click this button to apply
the changes.
Click this button to apply the changes.
Understanding the Tool Box Menus
213