Installing An Internal Solutions Port - Dell B5465dnf Mono Laser Printer MFP User Manual

Additional printer setup

Installing an Internal Solutions Port

The controller board supports one optional Internal Solutions Port (ISP).
Note: This task requires a flat‑head screwdriver.
CAUTION—SHOCK HAZARD: If you are accessing the controller board or installing optional hardware or
memory devices sometime after setting up the printer, then turn the printer off, and unplug the power cord
from the electrical outlet before continuing. If you have any other devices attached to the printer, then turn
them off as well, and unplug any cables going into the printer.
Warning—Potential Damage: Controller board electronic components are easily damaged by static electricity.
Touch a metal surface on the printer first before touching any controller board electronic components or
connectors.
1
Access the controller board.
For more information, see "Accessing the controller board" on page 29.
2
If a printer hard disk is installed, then remove the printer hard disk first.
For more information, see "Removing a printer hard disk" on page 45.
3
Unpack the ISP kit.
1
2
3
4
4
ISP solution
Screw for attaching the plastic bracket to the ISP
Screws for attaching the ISP mounting bracket to the controller board shield
Plastic bracket
1
2
3
36