Table of Contents
Advertisement
J. Troubleshooting
Refer to the symptoms and measures listed below before sending the camera for repairs. If the problem
persists, contact your nearest Ricoh Service Center.
Power Supply
Symptom
The power does not
Batteries are not loaded. Or they are exhausted.
come on.
The AC Adapter is not connected correctly.
Because the camera overheated the power was auto-
matically turned off.
The power cuts out
The camera was left unattended and unused, so Auto
during use.
Power-Off shut it off.
Batteries are running low.
The power does not
Camera malfunction.
go off.
Cannot recharge the
Battery life.
batteries.
Batteries run out
They are being used in extreme high or low tempera-
quickly.
tures.
Many shots are being taken in dark places inside,
requiring flash.
Shooting
Symptom
Even if I press the but-
Batteries are not loaded. Or they are exhausted.
ton, the camera does
not shoot.
The power is not on. Or the camera is not in Shooting
Mode.
The shutter button is not pressed all the way.
The Memory Card is not formatted.
The Memory Card does not have any free space.
End of Memory Card life.
The flash is recharging.
The SD Memory Card is "locked".
The SD Memory Card's contact surfaces are dirty.
I cannot check shot
The image confirmation time is too short.
images.
Cause
Cause
217
Measure
Load the batteries correctly. Recharge or use the AC
Adapter.
Reconnect it properly.
Wait until the temperature of the camera returns to
normal. Do not attempt to cool the camera suddenly.
Turn the power back on.
If you are using alkaline batteries, replace them. If you
are using a rechargeable battery, recharge it or use
the AC Adapter.
Reload batteries.
If using the AC Adapter, reconnect it.
Replace the batteries with a new set.
-
-
Measure
If using alkaline batteries, replace the batteries with a
new set. If using rechargeable batteries, recharge or
use the AC Adapter.
Turn the power on and turn the Mode Dial to Shooting
Mode.
Press the shutter button all the way.
Format the card.
Load a new card, or delete unwanted files.
Load a new Memory Card.
Wait until the flash lamp stops blinking.
Release the "Lock (write-protection)".
Wipe off with a soft, dry cloth.
Lengthen the image confirmation time.
Appendices
Page
P.12
P.13
P.14
P.14
-
P.16
P.123
P.12
P.13
P.14
P.12
P.13
P.14
P.13
-
-
Page
P.12
P.13
P.14
P.16
P.10
P.36
P.121
P.18
P.101
P.18
P.51
P.18
-
P.126
Advertisement
Table of Contents
