Replacing Frypot - Frymaster FMCFE Service & Parts Manual

MASTER JET CF SERIES ATMOSPHERIC GAS FRYERS
1.8.11 Replacing Pilot Assembly or Thermopile (cont.)
3. To replace the complete pilot assembly:
a. Disconnect the pilot tubing from the bottom of the pilot assembly.
b. Remove the screw from the pilot mounting-bracket to release the pilot assembly.
c. Disconnect the thermopile fitting from the gas valve pilot coil.
d. Reverse steps a through c to install the replacement pilot assembly.
4. Reinstall the burner assembly by reversing steps 1-8 of Section 1.8.9.

1.8.12 Replacing Frypot

1. Drain the frypot.
2. Remove all accessories (e.g., frypot covers, basket lift arms, etc.) from the fryer.
3. Disconnect the fryer from gas and electrical supplies.
4. Remove the screws from the top-cap above the control panel and lift it up and off the fryer(s).
5. If the fryer is equipped with other than a thermostat control, skip to Step 10.
6. Perform steps 1-6, section 1.8.2.
When handling the thermostat, do not rotate the shaft more than two turns in either
direction. Doing so will cause damage to the thermostat.
7. For fryers with other than thermostat controls, perform steps 1-4, section 1.8.1.
8. Disconnect the 12-pin plug from the back of the interface board. Use a pin pusher to remove the
temperature probe leads (pins 1 and 2) and the high-limit thermostat leads (pins 6 and 8) from
the plug. Leave all other wires connected. Leave the interface board lying on the shield.
9. Remove the louvered frame above the control panel opening.
10. Remove the screws securing the component shield to the fryer.
11. Disconnect the wires from components in component shield and mark to facilitate reconnection.
12. Disconnect the wires from the gas valve terminal block.
reconnection.
CHAPTER 1: SERVICE PROCEDURES
CAUTION
1-18
Mark each wire to facilitate