Frymaster FMCFE Service & Parts Manual page 21

MASTER JET CF SERIES ATMOSPHERIC GAS FRYERS
1.8.9 Replacing Burner Ceramic Targets (cont.)
10. To replace only the ceramic targets, straighten the target locking tabs with a pair of needle nose
pliers or a screwdriver, and slide the target up and off the bracket. Slide the replacement target
onto the bracket and bend the locking tabs inward towards the burner target.
Straighten lock-tab
to remove ceramic
target.
To replace the entire target assembly, use a ½-inch (13 mm) box end wrench to remove the two
brass orifices that hold the assembly to the burner manifold. Position the new assembly and
replace the orifices.
Use extreme care to prevent cross-threading and stripping when reinstalling the
11. Reverse steps 1-8 to reinstall the burner assembly. Check spacing and alignment of targets in
accordance with Section 1.6.
CHAPTER 1: SERVICE PROCEDURES
WARNING
brass orifices.
1-16
Remove
damaged target
by lifting up from
bracket. Install
new target and
bend lock-tab in
to lock target in
bracket.