Xerox DocuMate 3220 User Manual page 115

The options on the Page Settings tab, in the Scan Configuration Properties window will affect the job
separation options as described below:
Skip blank originals
• The Sensitivity you set for this feature is the one that is used when scanning. The sensitivity level
you set in the Options tab will be ignored.
• When you are scanning in Simplex mode and the selected job separator is
, the job separation occurs first and a new file will be created each time a blank page is
detected
detected. If you want a single file created with the blank page discarded, deselect the job
separation feature on the Options tab.
Note that when scanning Duplex, both sides of the page must be blank for the job separation to
occur. If both sides of a scanned page are blank, the job separation occurs first and a new file will
be created each time a blank page is detected. If you want a single file created with the blank
page discarded, deselect the job separation feature on the Options tab or remove the blank page
from your scanning batch.
• If you select
When the number of images reaches
pages will be discarded first, and then the number of images scanned will be counted. For
example, if you scan 12 pages and 3 are blank, the total number of images counted for the job
separation will be 9 not 12.
, and input a number in the control box, any blank
Xerox
When a blank page is
® ® 115
DocuMate 3220
User's Guide