Manually Setting The Printer's Ip Address - Xerox DocuPrint C3290 FS User Manual

Manually Setting the Printer's IP Address

Note:
Verify that your computer has a properly configured IP address for your network. Contact your
network administrator for more information.
If you are on a network without a DHCP server, or in an environment where the network administrator
assigns printer IP addresses, you can use this method to manually set the IP address. Manually setting the
IP address overrides DHCP and AutoIP. Alternatively, if you are in a small office with a single PC and use
a dialup modem connection, you can manually set the IP address.
Information Required for Manual IP Addressing
Information
Internet Protocol (IP) address of the printer
Network Mask
Default Router/Gateway address
Using the Control Panel
To manually set the IP address:
1. On the control panel, press the System button.
2.
Select the Admin menu, and then press the OK button.
3. Select the
Network Setup
4. Select the menu, and then press the OK button.
TCP/IP
5.
Select
Get IP Address
6. Select , and then press the OK button.
Panel
7.
Select IP Address
press the OK button.
menu, and then press the OK button.
, and then press the OK button.
under the TCP/IP menu and use the arrows to configure the IP values, and then
Configuring the Network Address
Comments
Format is xxx.xxx.xxx.xxx, where xxx represents a
decimal number from 0–255.
If you are unsure, leave this blank; the printer chooses
an appropriate mask.
Router address is required to communicate with the
host device from anywhere other than the local network
segment.
4-49