Wireless Client Mode; Wireles Client Mode; Connection Status - Planet WAP-6000 User Manual

4.2 Wireless Client Mode

WAP-6000 can also work as an Ethernet client bridge to connect up to 16 Ethernet device into wireless
network. In order to setup the WAP-6000 to work in Ethernet bridge mode, you need to choose "Wireless
Client" mode and click "Apply" at System Properties page. You also need to reboot the WAP-6000. After
the system reboot is done, you can see the page as below. Status page shows the WAP-6000 is now
working in Wireless Client mode.

4.2.1 Connection Status

- -
21