Table of Contents
Advertisement
4.1.3 System Properties
Device Name
Country / Region
Operation Mode
4.1.4 Administration
- -
You may assign any name to the WAP-6000. Memorable, Unique names are
helpful especially if you are employing multiple access points on the same
network. The device name needs to be less than 32 characters. After verify
the name you input and click "Apply" to save the setting.
Here you can set the WAP-6000 to follow different country and region
regulations.
The default operation mode is Access Point; this mode connects your
wireless clients to a wired network. In most cases, no change is necessary.
You can switch operation mode to Wireless Client, Repeater or Wireless
Bridge mode depends on your application. Wireless Client mode can allow
AP act as a client within its range. Your Ethernet devices behind the AP client
can connect to a remote AP. Repeater is able to retransmit the signal of a
remote AP. Choose repeater mode if you want to extend the range of your
original AP. Wireless Bridge mode allow you to create a wireless connection
to connect the networks between different building. You may check to the
section 4.2/4.3 and 4.4 for more details of those operating mode.
11
Advertisement
Table of Contents
