Wireless Lan Adapter - Packard Bell EasyNote ST Disassembly Manual

66666
Release the clip on each side securing the memory module; the module will eject upwards.
3.
Carefully remove the memory module from the socket.
4.
Note: In case two memory modules have been installed, you have to remove the top module first before you can
remove the one underneath.

Wireless LAN Adapter

To remove the wireless LAN adapter (mini PCI Express), first remove the battery (see
page 4) and then perform the following steps:
1. Remove the two screws securing the memory compartment cover (see
2. Lift the cover upwards from the left. There are two tabs holding the cover in place on the
right. Raise the cover until you can remove it from the casing (see
3. Carefully disconnect the two WiFi antenna cables.
Fig. 5 Removing memory module.
Fig. 6 Location of WiFi antenna cable connectors and screws.
Packard Bell EasyNote ST Disassembly Manual
Battery on
Fig. 4 on page 5).
Fig. 4 on page 5).
6