Recalling Preset Memory Groups - Panasonic AWRP120GJ Operating Instructions Manual

Operating preset memory groups (PMEM GROUP)
Registering the preset memory to recall when in ALL
mode
1 .
Press the MENU button to turn on its indicator .
2 .
Open PM GRP1 menu [31] .
1 . P M G R P 1 M O D E
3 .
Turn the F1 dial to display the "12 . PM GRP1 ALL" item .
1 2 . P M G R P 1 A L L
4 .
Turn the F2 dial to select a preset number, and then
press the F2 dial to confirm the selection .
A L L
P R E 0 0 1
(continued)

Recalling preset memory groups

Pressing a button to recall a preset memory group
Use PM GRP 1 to PM GRP 4 to recall preset memory groups.
PM GRP 1 to PM GRP 4 buttons
1 .
Press the SHIFT button to turn on its indicator .
2 .
Press the PM GRP 1 button .
When the operation mode of PMEM GROUP1 is "SEPARATE":
Simultaneously recalls each remote camera preset memory
registered to the "2. PM GRP1 1/10" to "11. PM GRP1 10/10"
items.
When the operation mode of PMEM GROUP1 is "ALL":
The preset memory registered in the "12. PM GRP1 ALL" item is
recalled for all of the remote cameras registered to the unit.
z Preset memory is not recalled for a remote camera for which
"NoAsign" is set in CTRL TYPE menu [36].
Note
z If the USER ENABLE button indicator is off, operation of the
PM GRP 1 to PM GRP 4 buttons is not possible. Perform
operation while the button indicator is on.
Recalling a preset memory group by GPI input
A preset memory group can be recalled by contact input of the TALLY/
GPI connector on the rear panel of the unit.
<PIN numbers and preset memory groups>
Signal
Pin number
name
19 GPI IN 1
7 GPI IN 2
20 GPI IN 3
8 GPI IN 4
⇒ "Control interface for external devices" (page 43)
USER ENABLE button
SHIFT button
Corresponding preset memory group
PMEM GROUP 1
PMEM GROUP 2
PMEM GROUP 3
PMEM GROUP 4
17