40
Tiller brackets
If the tiller is higher or lower than the mounting socket, you can use a
Raymarine tiller bracket to vary the tiller pin offset so the pilot is
horizontal.
Identifying the correct tiller bracket
1. Clamp the tiller on the boat's center line.
2. Measure dimension D (if the pushrod is above the tiller) or
3. Select the appropriate bracket from the following table:
Dimension D
(pushrod below tiller)
25 mm (1 in)
51 mm (2 in)
76 mm (3 in)
102 mm (4 in)
127 mm (5 in)
ST1000 Plus & ST2000 Plus Tiller Pilots - Owner's Handbook
dimension E (if the pushrod is below the tiller).
D
Dimension E
(pushrod above tiller)
51 mm (2 in)
76 mm (3 in)
102 mm (4 in)
127 mm (5 in)
152 mm (6 in)
Bracket
part no.
D009
D010
D011
D159
D160
D3194-2