Using Track Mode; Selecting Track Mode - Raymarine ST1000 Plus Tiller Pilots Owner's Handbook Manual

Chapter 2: Using the Tiller Pilot

2.4 Using Track mode

In Track mode, the tiller pilot maintains a track between waypoints
created on a navigation system. The tiller pilot computes any course
changes to keep your boat on track, automatically compensating for
tidal streams and leeway. To operate in Track mode, the tiller pilot
must receive cross track error information from either:
•
•

Selecting Track mode

When you select Track mode, the tiller pilot can acquire the track in
one of two ways:
•
•
Automatic track acquisition
If cross track error and bearing to waypoint data are both available
(via SeaTalk or NMEA), the pilot can acquire a track automatically:
1. Bring the boat to within 0.1 nm of track.
2. Press auto .
3. Press -10 and +10 together to enter Track mode.
4. An alarm will sound and the display will alternate between:
a SeaTalk navigator, or
a non-SeaTalk navigation system transmitting NMEA 0180 or
0183 data
automatic acquisition – when both cross track error and bearing to
waypoint data are available
manual acquisition – when Cross Track Error is the only available
information
• the bearing to waypoint, and
• the direction the boat will turn to take up the new track
Current
heading
15
Waypoint
at 058˚
D3277-2