Toshiba e-STUDIO500P Service Manual page 122

260.xx Paper Jam displays, envelope stops in feeder paper path
FRU
1 Kick rolls/feed rolls/drive
rolls
2 Deflector gap adjustment
Envelope feeder multifeeds or may not display a 260.xx Paper Jam message
FRU
1 Envelopes
2 Deflector
3 Restraint roll bias spring
260.xx Paper Jam displays, an envelope stopped in the paper path of the feeder
and an envelope also stopped in the base printer paper path
FRU
1 Latch lever
2-86
Service Manual
Action
Check all the rolls for oil, grease, or other contamination. If you find a
problem, clean the rolls. If this does not correct the problem, replace
the envelope feeder.
Check the deflector gap adjustment. The adjustment may be too
narrow. If the adjustment is correct, replace the envelope feeder
option.
Action
Check the envelopes being used in the feeder. Check for signs of the
envelopes being stuck together or signs of glue. Make sure the flaps
are not interleaved.
If the envelopes meet the guidelines and are properly loaded, go to
step 2.
Check the deflector gap adjustment. The adjustment may be too
wide.
If the deflector gap adjustment is correct, go to step 3. If not, replace
the envelope feeder option.
Check for a missing, broken or incorrectly installed restraint roll bias
spring. If incorrect, replace the envelope feeder option.
Action
Make sure the tip of the latch lever is centered in the opening in the
floor of the paper path. The latch lever may not be detented on the
latch. If no problem is found and the problem persists, replace the
envelope feeder option.