Table of Contents
Advertisement
When you are finished, press ENTER at the message: Press
ENTER to Confirm ... to save your selections, or press ESC at any
time to cancel them.
LAN-to-LAN Application
A typical LAN-to-LAN application is to use the Prestige to call
from one office to another office such that stations on one network
have access to stations on the remote side and vice versa. You will
need to configure a Remote Node in order to dial out to another
office.
Figure 9-1 Bridge Ethernet Setup
Handle IPX - Set this parameter to None if there is no IPX
traffic on the LAN or if you do not want to apply any special
handling for IPX. Set it to Client if there are only client
workstations on the LAN. Set to Server if there are only IPX
servers on the LAN.
If there are both clients and servers on the LAN, then the
setting depends on if the local clients will access the remote
servers. If they do, set to Client and set Dial-On-Broadcast in
menu 11.2 to Yes to allow the client queries to trigger the call.
If they do not, set it to Server .
Bridging Configuration 89
Advertisement
Table of Contents
