Vauxhall 2009 Tigra Owner's Manual page 119

Hide thumbs Also See for 2009 Tigra:
Table of Contents

Advertisement

As soon as the vehicle starts to swerve
(understeer/oversteer), engine output is
reduced and the wheels are braked
individually. This considerably improves
the driving stability of the vehicle on
slippery road surfaces.
Plus
ESP®
is ready for operation as soon
as the ignition is switched on and control
indicator v goes out.
Plus
When ESP®
comes into action, v
flashes.
The vehicle is now in a critical situation;
Plus
ESP®
allows you to keep control of
the vehicle and reminds you to match your
speed to the road conditions.
9
Warning
Do not let this special safety feature
tempt you into taking risks when driving.
Traffic safety can only be achieved by
adopting a responsible driving style.
Adapt speed to the road conditions.
Control indicator v
The control indicator illuminates for a few
seconds after the ignition is turned on. The
system is ready for operation when the
control indicator goes out.
Flashing during driving:
This shows the system has come into
action. The engine output may be reduced
(the sound of the engine changes) and the
vehicle may be braked automatically to a
small degree.
Driving and Operation
Illuminates while driving:
Fault in the system. Driving can be
continued. Poor road surface conditions
may however still cause vehicle stability
to be impaired.
Have the cause of the fault eliminated by
a workshop. The self-diagnosis integrated
into the system allows rapid fault
identification.
Control indicator v may illuminate when
the temporary spare wheel is in use.
The system is then deactivated.
Illuminates after interruption of power
supply e.g. after disconnecting battery.
After a power supply interruption the
steering angle sensor must be calibrated
to make the system operational:
z Automatic calibration by driving in
straight line at constant slow speed, i.e.
12 to 25 mph (20 to 40 km/h), on a level,
dry road,
z Manual calibration by turning steering
wheel from limit position to limit position.
If the control indicator does not go off after
successful calibration, observe notes in
previous column.
115

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents