140
Self-help
3. Twist bulb holder to separate from light
assembly.
4. Renew bulb.
5. Push to install the bulb holder into the
light assembly - then twist to secure.
6. Check that the wiring harness is located
correctly.
7. Locate light assembly into position,
ensuring that it is seated correctly.
8. Fit light assembly onto retaining pins
and replace 3 screws.
Reverse lights and fog tail light
1. Remove 2 screws (using the tool
supplied) and remove light assembly.
2. Twist bulb housing to separate from light
assembly.
3. Renew bulb.
4. Push to install the bulb holder into the
light assembly - then twist to secure.
5. Install light assembly with 2 screws.
Number plate light
1. Remove 2 screws (arrowed) and remove
lens.
2. Renew bulb.
3. Re-install lens; replace screws.