132
Self-help
1. Remove wheel trim, loosen the wheel
bolts with the ratchet and adapter. The
ratchet should turn anti-clockwise to
loosen the bolts - invert the ratchet if
necessary.
2. To raise vehicle, place lifting pad spigot
of the jack under the jacking hole
located nearest the wheel concerned.
3. Install adapter onto the jack and raise
the vehicle by turning the ratchet until
the wheel is clear of the ground.
4. Remove wheel bolts and replace wheel.
5. Refit wheel bolts and lower vehicle.
6. Tighten wheel bolts in criss-cross
sequence and refit wheel trim.
7. Stow the wheel, jacking equipment and
warning triangle 3.
Have the new wheel balanced on the
vehicle and have the torque of the wheel
bolts checked as soon as possible.
Tightening torque - see page 167.
Have defective tyre repaired and
balanced.