Port Status - TRENDnet TEG-S2400i User Manual

2-2. Port status

2-3. Port Statistics
2-4. Show MAC Table
2-5. Administrator
2-6. TFTP Update Firmware
2-7. Configuration Backup
2-8. Reset System
2-9. Reboot
2.2. Port status
This page provides current status of every port that depends on user's setting and the negotiation
result.
1. State: Display port statuses: disable or enable. "Unlink" will be treated as "off".
2. Link Status: Down means "No Link", UP means "Link".
3. Auto Negotiation: Display the auto negotiation mode: auto/force/Nway-force.
4. Speed status: Display 1000Mbps or 100Mbps or 10Mbps speed, port 1- 24 are 10/100Mbps, Port
25-26 are 10/100/1000Mbps.
5. Duplex status: Display full-duplex or half-duplex mode.
6. Flow Control: Full: Display the flow control is enabled or disabled in full mode.
Half: Display the backpressure is enabled or disabled in half mode.
7. Rate Control: Display the rate control setting.
- 15 -