Date And Time Setting; Default Setting - Aztech WIPC402 User Manual

AZTECH WIPC402 IP CAMERA USER MANUAL v1.0

7.5.2 Date and Time Setting

Please refer to above Figure 33. Select the time zone first. There are three options to set the
time and date. One is manually, another is keeping the same as the time and date of the
computer, and the third one is getting it from the NTP server.

7.5.3 Default Setting

Reboot button to restart the equipment, if you have set the pre-position, and it will turn
this position.
Click "Factory Default" button, equipment will restart and get back to all the default
settings.
Click "save", it will save all the present settings.
"Restore" part, select the setting file you have saved, click OK, it will recover all the
settings.
"Upgrade" part, select the firmware file for upgrading, click OK, and you are able to
upgrade the equipment. After the upgrading, equipment will restart. Upgrading takes a
little time, please wait patiently. If upgrading is finished, it will show you a message to
remind you.
Figure 33
29