Conferencing Center 3.0 Installation Manual
Conference Finished
This sample failure route will define the action taken by the system when a participant dials into a
conference that has already ended. Again, this is only a sample route in which the conference participant
is played a message stating that the conference already finished.
To set up this failure route:
1. Create a recording similar to the following:
•
"Sorry, the conference you are trying to join has already finished."
2. Click
Basic Actions on the tool bar and select
3. Click in the right-hand pane to place the action.
4. Open the Properties for
•
Change the Token Name to Play Finished.wav.
•
In the Entry Prompts tab, click the
wav file you created in step 1.
•
Click Close and OK.
5. Connect Conference Finished to
6. Click
Telephony Actions on the tool bar and select
7. Click in the right-hand pane to place the action.
8. Connect
Play Finished.wav to
9. Click
Save & Make Live on the toolbar.
24
Generic.
(green cross), click
Play Finished.wav.
Disconnect.
Generic.
and select the name of the
Disconnect.