H5 - 3 Pin Red Antenna/Receiver Connector; H6 - 3 Pin Door Lock Harness - Autopage Car-Pro CPX-RS2 Installation Manual

H5. Red 3-PIN CONNECTOR. – Windshield Receiver /Antenna
The windshield receiver/antenna mounts on the windshield (Inside). We suggest you mount it on the lower left or upper
left-hand side of windshield.
Warning! Do not mount in such a manner that it obstructs the driver's view.
- For Optimum Performance the receiver/antenna whip must be vertical facing up.
- Remove the protective tape backing.
- Carefully align the receiver/antenna and apply to windshield.
- Route the black connector wire behind the trim and connect to receiver/antenna.
- Connect the other end to the control module.
- Special considerations must be made for windshield glass as some newer vehicles utilize a metallic
shielded window glass that will inhibit or restrict RF reception. In these vehicles, route the windshield
receiver/antenna module away from metallic shielded window glass as far as possible.
H6. White 3-PIN DOOR LOCK CONNECTOR
NEGATIVE TRIGGER DOOR LOCK SYSTEM
Blue Wire Door Unlock
Green Wire Door Lock
5-WIRE ALTERNATING DOOR LOCK
Green Wire
86
3 Pin Plug
87 87a 30
To Alarm
85
86
87 87a
30
85
Blue Wire
To Door
Lock Motors
RS2
1.
Blue
2.
Green
Locking
Master
Switch
To Exiting
Door Lock Relay
Master Door
Lock Switch
Splice
Cut the Existing
X
Unlock Wire
Splice
+12V
X
Wire ( - ) Unlock
( - ) Lock Green
Wire
3-WIRE POSITIVE DOOR LOCK
Green Wire
3 Pin Plug
87
To Alarm
87
Blue Wire
+12V
Cut the Existing
Lock Wire
9
Blue
Master Door
Lock Switch
86
Unlock Wire
87a
30
85
+12V
86
87a
30
85
To Door
Lock Motors
August, 2005
+12V