Iactive Disarming - Unlock & Disarm; Tamper Disarming; Pathway Illumination; Two Steps Door Unlock - Autopage RS-725LCD Operation Manual

by-pass, press the transmitter
status.
I. ACTIVE DISARMING – UNLOCK & DISARM:
1. Press button on the transmitter.
2. The siren will chirp twice and the parking lights will flash twice indicating that the
security system is now disarmed. The vehicle's doors will unlock and the dome
light will turn on for 30 seconds upon disarming. (Note: Power door locks and
dome light must be installed with the security system.)
System Disarm Doors Trigger
Shock Sensor Trgr Ignition Trigger
TAMPER DISARMING: If the alarm is triggered upon disarm, the system's siren will
chirp 4 times, and the parking lights will flash 3 times.
PATHWAY ILLUMINATION: When receiving an unlock /disarm signal, this feature will
turn the parking lights "ON" for 30 seconds and for 10 seconds upon the lock signal.
TWO STEPS DOOR UNLOCK: This feature will independently unlock the driver's
door only when disarming the security system. Pushing the
within 3 seconds will unlock the other doors.
AUTOMATIC RE-ARM: If this feature is selected, the security system will
automatically re-arm itself in 60 seconds after disarming with remote transmitter.
Automatic rearm will cancel if any door is opened before the 60 seconds timer has
elapsed.
J. DISARMING WITHOUT A TRANSMITTER

OVERRIDES THE ALARM WITHOUT PASSWORD PIN CODE:

(Factory Default Setting)
The Override function may be used if the remote transmitter is lost or inoperative.
1. Enter the vehicle and turn the ignition switch to 'ON' position.
2. (Alarm will sound.)
3. Within 10 seconds push and release the valet switch. The alarm will stop sounding
and enter the disarm mode. You can now start and operate the vehicle normally.
OVERRIDE THE ALARM WITH PASSWORD PIN CODE:
Unlike valet switch easily found, and defeated, this security system allows the
consumer to program a password pin code. Offering a higher level of security.
1. Enter the vehicle and turn the ignition switch to 'ON' position. (Alarm will sound.)
2. Within 5 seconds, enter your chosen first digit code by pressing and releasing the
Valet Switch. (When finished above procedures, system's siren will stop alarming,
lights will stop flashing, but the vehicle can't be started.)
3. Within 15 seconds of the last digit code enter (the 1st code), then turn the Ignition
Switch "OFF" and then "ON".
or buttons and the system will return to normal
Trunk/Hood Trigger
Clear The Flash Icon:
Press the button 3 times within 3
seconds to clear the flash icon on the LCD
screen transmitter.
13
button a second time