Automatic Rearming; Trigger Test - Autopage RF-503 Operation Instructions Manual

Hide thumbs Also See for RF-503:

Table of Contents

NOTE: If domelight supervision has been installed, the vehicle's domelight(s) will illuminate with the

disarm signal. The domelight will remain on for 60 seconds, or immediately turn off when the ignition is

switched on.

F. AUTOMATIC REARMING

The RF-503 is equipped with an automatic rearming circuit that will return the alarm to a fully armed

state if a door is not opened within 60 seconds after disarming, regardless of which method was used to

arm. The automatic rearm circuit can be eliminated at the time of installation.

G. BREACH WARNING

The RF-503 is equipped with a BREACH WARNING to tell you, upon disarming, if the alarm has

been triggered in your absence. If an alarm breach has occurred, the LED STATUS INDICATOR will

be flashing in a 2 flash/hold sequence. Press Button I on the remote transmitter. The vehicle horn or

siren will chirp four (4) times, and the parking lights will flash four (4) times. Enter the vehicle in the

normal manner.

H. IGNITION CONTROL POWER DOOR LOCK SYSTEM

When installed with remote power door lock/unlock, the vehicle's door will automatically lock when the

ignition is switched on. The doors will automatically unlock when the ignition is switched off. To avoid

any undesirable lock-out, the doors will not lock if any door is left open.

This feature is selectable at the time of installation. If the ignition control door lock system is not chosen,

the doors will not lock automatically in the passive arming mode. However, the doors will lock in the

manual arming mode, and with the automatic rearming mode.

NOTE: The ignition control power door lock system will not function on vehicles with vacuum/electric

door lock systems, such as those found on some Mercedes-Benz, and Audi vehicles.

NOTE: Use of the ignition control door lock system will not interfere with any factory installed child

door lock safety system.

I. TRIGGER TEST

After arming the RF-503 in either the PASSIVE or MANUAL mode, test the system in the following

manner.

1. Open any door or other protected opening. The vehicle horn or siren will immediately sound, and the

parking lights will begin flashing.

2. If the prewarning feature is activated, the RF-503's SIS-5 shock sensor will respond to a light shock

with a horn or siren chirp, and trigger the alarm when a heavier shock is detected.

Table of Contents