Packard Bell EasyNote MB Series Disassembly Manual page 14

5. Remove two screws located near the edges on the rear side bottom of
the unit.
6. Remove the two screws from the rear side of the unit.
7. Remove the 2 hinge covers. You can leverage them loose with a small
flathead screwdriver.
8. Open the LCD panel to an upright position (90 degree angle with the
base unit) and lift the panel out.
Note: Pull the WLAN antenna and LCD cable through the hole in the top cover one by one
(there is no room to pull them through at the same time). During disassembly, it is easiest to
first put the LCD cable back and the WLAN antenna second to ensure the WLAN antenna is
guided to the right place.
Fig. 18 The LCD cable.
Fig. 19 The bottom of the notebook.
EasyNote MB Disassembly Manual 14