Table of Contents
Advertisement
Overview
This document contains step-by-step disassembly instructions for the EasyNote M3
notebook. The instructions are illustrated where necessary with images of the part that
is being removed or disassembled. Furthermore, the screws that are removed are
shown next to the image of the parts themselves.
Packard Bell reserves the right to make changes to the EasyNote M3 notebook without
notice.
Technician Notes
Only technicians authorized by NEC Computers International B.V. should attempt to
repair this equipment. All troubleshooting and repair procedures are detailed to allow
only subassembly/module level repair. Because of the complexity of the individual
boards and subassemblies, no one should attempt to make repairs at the component
level or to make modifications to any printed wiring board. Improper repairs can create a
safety hazard. Any indication of component replacement or printed wiring board
modifications may void any warranty or exchange allowances.
Disassembly Instructions
When disassembling the system unit, follow these general rules:
Turn off the power and remove the battery.
Disconnect all cables and peripherals.
Label all removed cables. Note where the cable goes and in what position it
was installed.
Do not disassemble the system into parts that are smaller than those specified
in the instructions.
Reassembly Instructions
Reassembly is the reverse of the disassembly process. Use care to ensure that all
cables and screws are returned to their proper positions. Check that no tools or any
loose parts have been left inside the chassis. Check that everything is properly installed
and tightened.
Required Tools
All disassembly procedures can be performed using the following tools:
Philips (#2 bit) screwdriver
A small flat bed screwdriver
Packard Bell Easynote M3 Disassembly Manual
2
Advertisement
Table of Contents
