Western Digital WD Serial ATA RAID Controller User Manual page 13

5. Connect your system case's 2- or 4-pin LED cable to the LED connector on the WD
SATA RAID Controller.
6. Attach one SATA data cable to each SATA hard drive. Then attach the other end(s) of the
cable(s) to the connector(s) on the WD SATA RAID Controller.
Note: The WD SATA RAID Controller is a PCI Plug-n-Play (PnP) device. No changes
are necessary in the Motherboard CMOS Setup for resources or drive types in most
applications..
After completing the physical installation process above, you must create an array before
installing an operating system on the drive(s) or using an existing operating system on a drive.
Proceed to "Creating a Disk Array" on page 10.
Port 2
(Serial)
Management
connector
Figure 2. WD SATA RAID Controller Connectors
WD SERIAL ATA RAID CONTROLLER
USER MANUAL
Port 1
(Serial)
INSTALLING THE SATA RAID CONTROLLER - 9