Trane CLCH Installation Operation & Maintenance page 10

4.2 Stacked Units (Top and
Bottom)
Lower the top unit into position on top of
the bottom unit, taking care not to
damage the sealing gaskets.
Fit the self-tapping screws to the fixing
brackets, which are already positioned on
the top edge of the bottom unit,drilling into
the top unit section (10A) or base frame
(10B) depending on product, in order to
secure the top unit to the bottom unit (see
Figure 10).
Fix into position any internal joining strips
and/or brackets that are provided, and
then seal up any common sections in the
top and bottom units.
4.2.1. Stacked units (Side by Side)
Manoeuvre the two units into their correct
positions, taking care not to damage any
sealing gaskets.
Fix through the fixing brackets which are
located at both ends of the units in order
to secure the units together. Also fix into
position any base frame, unit end, and
roof joining brackets that are provided.
Fix into position any internal joining strips
and/or brackets that are provided, and
then seal up any common sections in
both of the units.
If you require further assistance or have
any questions please contact your local
Trane sales office.
4.3 Assembly of Flatpacked
Units
The unit is fully assembled in the factory
on a flat and level surface. Prior to
disassembly for flat packing (see Figure
11) all items are marked
alphanumerically. All items marked "A"
are joined at the fixing indicated at this
point. These markings are on labels on
internal surfaces so they are not evident
upon completion. DO NOT remove labels
until assembly is complete.
We would recommend opening one unit
at a time to avoid confusion.
10
4. Assembly and
Installation
1
2
Figure 10A
Figure 10 A/B
Figure Notes:
1. Self tapping screws
2. Bottomframework of TOP unit
3. Fixing bracket
4. Top framework of BOTTOM unit
Figure 11
4
3
Figure 10B
CLCH-SVX05A-GB