Installation Procedure - Trane LPC Install And Operation Instructions

Transition Kit Installation
The LPC was designed with the same
aspect ratio as the M-Series unit. The
transition kit is designed to mate up M-
series modules with the LPC. The LPC
mates up with the same size M-series
with the exception of sizes 12 and 17 . Due
to fewer cabinet sizes with the LPC, these
sizes mate up to the next size larger M-
series unit. See figure I-IP-4 for installation
istructions of the finishing kit.
The table below shows the mated sizes.
The external static pressure from the M-
series module needs to be included in the
external static of the LPC to ensure the
unit can handle the extra static.
LPC M-Series
3 3
6 6
8 8
10 10
12 14
14 14
17 21
21 21
25 25
30 30
To install the transition kit, follow the steps
listed below:
1. Apply Gasket Tape supplied in kit
between the LPC and MCC Module.
2. Use Self Drilling screws supplied with
the kit on the M-series side. The LPC
unit will have screw holes that match
the attachment brackets.
Finishing Kit Installation
The LPC was designed to be used without
gasketing and to be assembled with
common job site material. For
circumstances where gasketing is
desired, or when it is necessary to use
only factory provided materials, the
finishing kit is available. See Figure I-IP-5
for installation instructions of the
finishing kit.
To install the Finishing Kit, follow the steps
listed below:
1. Apply Gasket Tape supplied in kit
between the LPC unit and accessory
2. Use screws supplied with kit to join
with accessory module
3. Use supplied hardware to join feet
together
LPC-SVX01C-EN
Installation
Apply Gasket Tape
supplied in kit
between the LPC
and MCC Module
3 MCC
3 LPAH
Module
Figure I-IP-4. Transition Kit Installtion LPC
Apply gasket tape
supplied in kit
between the LPC
unit and accessory
Direction of airflow
Accessory Module
Use supplied hardware
to join feet together
Figure I-IP-5. Finishing Kit Installation LPC
installation
procedure
Use Self drilling screws supplied
with the kit on the M-series side.
The LPC unit will have screw holes
that match the holes in the
attachment brackets.
6 – 30 LPAH
Note: LPC size 12 cannot be mated to size 12 MCC. Also,
LPC size 17 cannot be mated to size 17 MCC. Size 12 LPC
must be mated to size 14 MCC. Size 17 LPC must be
mated to size 21 MCC.
Use screws supplied with kit to
join unit with accessory module
6 – 30 MCC
Module
LPC Unit
43