Battery Installation - Dimplex DF3033ST Owner's Manual

Operation
independent frequencies to
prevent interference with other
units.

Battery Installation

1. Depress tab on the battery
cover on the back of the
remote control and remove
battery cover (Figure 5).
2. Install two (2) aaa batteries
into the remote control
(included).
3. Ensure child lock is in the
"unlocked" position (Figure 5).
4. Replace the battery cover.
!
NOTE: When the "baT"
symbol is present on
the remote control it is
recommended to replace the
batteries promptly, to maintain
full functionality of the remote/
fireplace. The remote control
has a battery backup time of
only several hours.
battery must be recycled
or disposed of properly.
Check with your Local
authority or Retailer for recycling
advice in your area.
12
Figure 5
Initializing/Reprogramming
the Remote Control
1. Plug cord into 120 volt wall
outlet.
2. Ensure the on/off Switch
located in the switch box on
the fireplace in the upper right
hand corner is in the
position (Figure 4a).
3. Set the 3 Position Manual
Control (Figure 4b) to
the Remote position (left
position).
4. Press and hold the
Initialization button on the unit
(Figure 4C).
5. While holding the Initialization
button, press the Flame/
heat on/off
remote control.
6. Release the Initialization
button on the unit.
batteries
Child Lock
on
button on the
www.dimplex.com