Dimplex DF3033ST Owner's Manual page 13

Operation
7. Press the Flame/heat on/off
button
heat function on.
Frequency Interference
If the fireplace does not respond
properly to the remote control,
the remote operating frequency
may have to be reset. The
remote control can send another
frequency code to the remote
control reciever to eliminate
interference.
①
Simultaneously press the
"Temperature Down" button and
the "Flame Speed Down" button
on the remote control (Figure 6).
②
"COD" will appear in place of
the sleep timer digits.
③
Release the "Temperature
Down" button and the "Flame
Speed Down" button.
④
Press the Initialization button
on the unit (Figure 4C).
⑤
Press the Flame/heat on/off
button button on the remote.
Your remote will now
have a different frequency
communicating with the fireplace.
to turn the Flame/
Remote Control Functions
(all letter references are to Figure 6)
B. Set Temperature
Press F button
on.
Press H to raise thermostat.
Press g to lower thermostat.
Press both H and g to change °F
to °C.
C. Dimmer
Press the F button
Flame/heat on.
Repeatedly press the J or I button
to decrease or increase the
brightness of the upper lights.
D. Flame Speed
Press the F button
Flame/heat on.
Press the L button to increase the
speed of the flame.
Press the K to decrease the
speed of the flame.
E. Sleep Timer
The Sleep Timer automatically
shuts off the fireplace after a
preset time (from 30 minutes to 8
hours).
Press the F button
fireplace on.
to turn fireplace
to turn the
to turn the
to turn the
13