Dimplex DF3033ST Owner's Manual page 17

Maintenance
Figure 9
Exploded view to show detail
Flicker Rod
into the rubber bushing on the
flicker motor shaft (Figure 9).
6. unscrew bulbs counter
clockwise.
7. Insert new bulbs.
8. Reconnect the log set LED
wire harness.
9. Install the log set by placing
the front, bottom edge of the
ember bed in the track behind
the front panel. once in
place, push down on the back
edge of the ember bed until
the rear tab snaps into place
under the Partially Reflective
Glass (Figure 10).
!
NOTE: Ensure the log set is
installed tightly under the back
ledge to prevent light leakage.
10. Replace glass assembly.
Upper Light Bulb Requirements
Quantity of two (2) clear
chandelier or candelabra bulbs
bulbs (3)
Figure 10
back
Ledge
Rear
Flicker
Tab
Motor
with an E-12 (small) socket base,
15 Watt rating.
Do not exceed 15 Watts per
bulb.
To access the upper light bulb
area:
1. Remove front glass assembly.
2. upper bulbs are located in
the upper left and upper right
corners of fireplace (Figure
8).
3. Remove the upper light cover
for each bulb (two (2) Philips
screws each).
4. unscrew bulbs counter
clockwise.
5. Insert new bulbs.
6. Re-install upper light bracket.
7. Replace glass assembly.
Log
Ember bed
Side Section
Front
Edge
17