Site Selection And Preparation; Fireplace Installation - Dimplex BF9000 Owner's Manual

Site Selection And Preparation

This section provides instructions
for selecting a location and
preparing the site to install the
fireplace into your Dimplex mantel
surround.
1. select a suitable location that
is not susceptible to moisture and
is away from drapes, furniture and
high traffic.
2. For ease of electrical hook
up you may wish to locate the
fireplace near an existing outlet.
!
NOTE:
A 15amp, 120 volt
alternating current (VAC) circuit
is required. A dedicated circuit
is preferred but not essential in
all cases. A dedicated circuit will

Fireplace Installation

1. Install the fireplace assembly
into the mantel. (refer to mantel
assembly instructions)
!
NOTE 1: A 15 Amp, 120
Volt circuit is required. A
dedicated circuit is preferred
but not essential in all cases.
A dedicated circuit will be
required if, after installation,
the circuit breaker trips or fuse
blows on a regular basis when
be required if, after installation,
the circuit breaker trips or fuse
blows on a regular basis when the
heater is operating. Additional
appliances on the same circuit
may exceed the current rating of
the circuit breaker.
3. store the fireplace in a safe
dry and dust free location.
! NOTE: The dimensions of
the fireplace are 30 inches
(762 mm) wide X 18 ⅞ inches
(479.5 mm) high X 9 ¼ inches
(235 mm) deep. The fireplace
does not require any additional
venting.
the heater is operating.
Additional appliances on the
same circuit may exceed the
current rating of the circuit
breaker.
!
IMPORTANT: If not using
a Dimplex mantel, the fireplace
must be installed in an enclosure
with the following MINIMUM
internal/opening dimensions
(Figure 1).
7