Dimplex BF9000 Owner's Manual page 15

Maintenance
Helpful Hints
It is a good idea to replace both
light bulbs at one time if they are
close to the end of their rated life.
Group replacement will reduce
the number of times you need
to open the unit to replace light
bulbs. Care must be taken when
removing the Log Set Assembly
as it contains LED's and
To Access The Lower Light
Bulb Area: (Figure 7)
1. remove front glass assembly.
2. Pull the back edge of the
plastic ember bed forward
until the rear tab releases
from the ledge located at
the bottom of the mirror.
! IMPORTANT: Only handle
the log set by the ember
bed.
! NOTE: Log set fits tightly
into firebox, some force
may be necessary to
remove.
3. set log set in front of
fireplace.
4. Disconnect flicker from
motor (see Figure 7).
5. unscrew bulbs counter
6. Insert new bulbs.
7. reconnect flicker to motor.
8. replace the log set by
wires.
! NOTE: Ensure the log set is
9. replace glass assembly.
Figure 7
clockwise.
inserting the front edge of
the log set and push down on
the rear edge of the ember
bed until it snaps into place
(Figure 8).
installed tightly under the back
ledge to prevent light leakage.
Flicker
15