Maintenance - Dimplex BF9000 Owner's Manual

Operation
control receiver in the fireplace:
1. Place the Main ON/OFF
Switch (Figure 5A) in the OFF
("o") position.
2. Wait a minimum of five (5)
seconds and then place the
Main ON/OFF Switch in the
remote Control ("=") position.
3. Within 10 seconds of changing
the switch position, press
the on button located on the
remote control transmitter
(Figure 6).
This will synchronize the remote
control transmitter and the
fireplace receiver.

Maintenance

Light Bulb Replacement
Allow at least five (5) minutes for
light bulbs to cool before touching
bulbs to avoid accidental burning
of skin.
Light bulbs need to be replaced
when you notice a dark section
of the flame or when the clarity
and detail of the log ember bed
exterior disappears. There are
two (2) bulbs under the log set,
14
! NOTE: You will have only 10
seconds to perform this last
step. Failure to do so will result
in these steps needing to be
followed again.
If you are still experiencing issues
with your remote control, contact
Dimplex North America Limited
Customer Service at 1-888-346-
7539, or visit the Dimplex website
at www.dimplex.com.
which generate the flames and
embers.
Light Bulb Requirements
Quantity of two (2) clear
chandelier or candelabra bulbs
with an E-12 (small) socket base,
60 Watt rating. Example: GE
60BC or Philips 60 CTC.
Do not exceed 60 Watts per
bulb.
www.dimplex.com