Table of Contents
Advertisement
4 – Playback
Folder playback (data CDs/SD cards/
USB flash drives)
With data CDs, SD cards and USB flash drives, you can set the
selected folder (current folder) as the playback area. Follow the
procedures below to set the playback folder. You can also set the
playback area to be all the tracks/files on the current media by
selecting
.
ALL PLAY
Setting the playback folder
1. While pressing and holding the main unit DISPLAY [SHIFT]
button, press the PLAY MODE/INTRO CHECK [PLAY AREA]
button (or press the remote PLAY AREA button) to set the
playback area to
.
FOLDER
2. Use the main unit FOLDER g/t [PITCH −/+, / ] buttons
or the remote FOLDER g/t [ / ] buttons to skip to the
previous or next folder.
This will skip to the beginning of the first track in the
previous or next folder. If you hold down one of these
buttons, you can skip through folders continuously in order.
NOTE
• When you skip to a different folder, it becomes the current
folder.
• During folder playback, repeat playback will play back all
tracks inside the current folder repeatedly.
• During folder playback, random playback will play back all
tracks inside the current folder randomly.
24
TASCAM CD-200SB
Programmed playback
To use programmed playback, you must set a program either
before or after setting the playback mode to programmed
playback mode. (See "Selecting the playback mode" on page
22.)
When in programmed playback mode, press the PLAY/PAUSE
button on the main unit or the remote control to start playback
of the set program in order from the first track (program step
01).
Press the main unit SEARCH m/, [.//, SELECT 5/
b] button or the remote search (m/. [SELECT 5] or
//, [SELECT b]) button to skip to the previous or next
program step.
When playback is stopped in program playback mode using an
audio CD, the total number of tracks in the program and the
total program time are shown.
When using a data CD, only the program number is shown.
When using an SD card or USB flash drive, the number and time
of the track being played back are shown.
NOTE
• To select programmed playback, when stopped, press the
main unit PLAY MODE/INTRO CHECK [PLAY AREA] button
or the remote PLAY MODE button.
• When using a data CD, SD card or USB flash drive, you
cannot set a program when the playback area is
Change the playback area to
current folder to be used in the program.
.
ALL PLAY
to enable tracks in the
FOLDER
Advertisement
Table of Contents
