Selecting The Playback Mode; Playback - Tascam CD-200SB Owner's Manual

4 – Playback

Selecting the playback mode

Press the main unit PLAY MODE/INTRO CHECK [PLAY AREA]
button or the remote PLAY MODE button to cycle through the
playback modes. During playback, however, you can only switch
among continuous, single and random playback modes.
To select programmed playback, press the main unit PLAY
MODE/INTRO CHECK [PLAY AREA] button or the remote PLAY
MODE button when playback is stopped.
The currently selected playback mode is shown on the display as
follows.
Indicator Playback mode
No indicator Continuous playback mode
Single playback mode
SNGL
Random playback mode
RAND
Program playback mode
PROG
The selected playback mode is retained even when the
power is turned off.
NOTE
Immediately after pressing the PLAY MODE/INTRO CHECK
[PLAY AREA] button on the main unit or the PLAY MODE button
on the remote control, the selected mode is shown on the main
display area as follows.
Continuous playback mode set:
Single playback mode set:
Random playback mode set:
Programmed playback mode set:
22
TASCAM CD-200SB
CONTINUE
SINGLE
RANDOM
PROGRAM

Playback

The following procedures assume that the necessary connec-
tions have been completed, the unit's power has been turned
ON and the media has been loaded.
To start playback, press the PLAY/PAUSE button on the main
unit or the remote control.
Stopping playback
8
Press the STOP button on the main unit or the remote
control.
Pausing playback
8
Press the PLAY/PAUSE button on the main unit or the
remote control.
In this manual, unless stated otherwise, explanations are given
assuming that the playback mode is continuous. (See "Playback
modes" on page 21.)