Table of Contents
Advertisement
Quick Start Guide—Basic Operation
IMPORTANT SAFETY PRECAUTIONS
Using the Effects
To apply effects to your bass sound, press the
open the
screen. When the
EFFECTOR
lighted as shown below, use the
of the effect banks (01–10).
After selecting an effect bank, select an effect preset by using
the down
(
) key to highlight the
CURSOR
¶
Then use the
keys to select a preset. Each preset
VALUE (+, –)
uses a different combination of effect modules. (See the
"Effect preset lists" on page 41.)
Press the right
key (
CURSOR
adjustment screen. Use the
level.
1
TASCAM CD-BT2
EFFECT
value is high-
BANK
keys to select one
VALUE (+, –)
PRESET
) to open the effect level
¥
keys to change the
VALUE (+, –)
NOTE
key to
You can change the parameter settings for every effect.
(For details, see "Using built-in effects" on page 31.)
Playing bass along with a CD
You can listen to the sound from both a CD and your bass at
the same time through headphones. To change the volume
balance between the CD and the bass, press the
open the
LEVEL
highlight the
BASS LEVEL
keys to adjust the bass volume. (See "Adjusting the input
–)
level" on page 30)
Turning off the power
value.
When you stop using the player, press the
the back of the unit for about one second. Release the switch
when "
TRAINER SERIES
Restoring all settings to original values
If you press and hold both the
the player power ON, the
After startup, follow the onscreen instructions and press the
¥/π key to restore every effect parameter, playback setting
and other adjustable setting to the values they were set at when
they unit was shipped from the factory.
screen. Press the right
CURSOR
value, then use the
POWER
" appears on the display.
and
keys when you turn
µ
≤
screen appears.
INITIALIZE
key to
LEVEL
key (
) to
¥
VALUE (+,
switch on
Advertisement
Table of Contents
