Quick Start Guide-Basic Operation; Preparation - Tascam CD-BT2 Owner's Manual

Quick Start Guide—Basic Operation IMPORTANT SAFETY INSTRUCTIONS
Let's start using the unit right away. In this section, we will
teach you the basics, including how to setup the unit, play a
CD, connect your bass and play along with prerecorded music.

Preparation

Turn the power on
Remove the battery case cover from the underside of the unit,
and insert four ordinary AA batteries, aligning them with the
+ and – symbols inside the case. (See "Batteries" on page 10.)
Turn the power ON after inserting the batteries.
Press and hold the
POWER
about one second. Release it when "
display. Start-up completes after a few seconds and the
screen appears.
DISPLAY
switch on the rear of the unit for
" appears on the
TASCAM
NOTE
You can also use a PS-P520 AC adapter (sold separately)
for power instead of batteries. Connect the AC adapter to
the DC IN 5V jack on the rear of the unit.
Setting a CD
All the controls for this device are on the CD tray cover.
The switch is on the front of the unit. Slide it left and
OPEN
open the tray cover. Put a CD in the CD tray and press it into
place gently until the disc clicks. Close the tray cover after
setting the CD.
TIME
NOTE
The keys cannot be used when the tray cover is open.
11
TASCAM CD-BT2