Licensing Information - Shure UHF-R Wireless User Manual

Overall Dimensions
49 mm L x 60 mm W x 17 mm D (1.9 x 2.38 x 0.66 in.)
Net Weight
62 g (2.2 oz.) without batteries
Wiring
TA4F Connector
TA4F
Microphone Element
Connector
NOTE: LAVALIER MIC TIES PINS 3 AND 4 TOGETHER—GUITAR CABLE DOES NOT.
LEMO Connector
Microphone Element
Connector
UR1M Transmitter RF Output:
Connector:
Actual Impedance:
Pin Assignments:
To fully interact with the Receiver, it is recommended to upgrade the UR4 firmware to 1.50 or higher and Shure Wireless Workbench to 5.0
Certification:
UR1M: Type Accepted under FCC Parts 74 (FCC ID: DD4UR1MA, DD4UR1MB, DD4UR1MC, DD4UR1MD, DD4UR1MF, DD4UR1MG, DD4UR1MRA,
DD4UR1MRB, DD4UR1MRC, DD4UR1MRG). Certified by IC in Canada under RSS-123 and RSS-102 (IC: 616A-UR1MA, 616A-UR1MB, 616A-UR1MC,
616A-UR1MD, 616A-UR1MRA, 616A-UR1MRB, 616A-UR1MRC).
The "EU Declaration of Conformity" can be obtained from Shure Inc. or any of its European representatives. For contact information please visit www.shure.com

LICENSING INFORMATION:

Licensing: A ministerial license to operate this equipment may be required in certain areas. Consult your national authority for possible requirements.
Changes or modifications not expressly approved by Shure Incorporated could void your authority to operate the equipment. Licensing of Shure wireless micro-
phone equipment is the user's responsibility, and licensability depends on the user's classification and application, and on the selected frequency. Shure strongly
urges the user to contact the appropriate telecommunications authority concerning proper licensing, and before choosing and ordering frequencies.
Information to User:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
Operation of this device is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired
operation of the device.
Note: EMC conformance testing is based on the use of supplied and recommended cable types.
The use of other cable types may degrade EMC performance.
TA4M
Connector
UR1M MIC JACK BOARD
Active Load
Audio
Ground
UR1M LEMO BOARD
Audio
Ground
Connector
SMA
50 Ω
Shell = Ground
Center = Signal
UR1M Transmitter Audio Input:
Connector:
Input Configuration:
Maximum Input Level:
(1 kHz, 1% THD)
TA4M Connector Pin
Assignments:
LEMO Connector Pin
Assignments:
REPLACEMENT PARTS AND ACCESSORIES
Furnished Accessories
Antenna, 470-530 MHz.....................................................................UA700
Antenna, 518-578 MHz.....................................................................UA710
Antenna, 578-698 MHz ....................................................................UA720
Antenna, 740-865 MHz ....................................................................UA730
Antenna, 944-952 MHz ....................................................................UA740
Threaded Locking Adaptor (UR1M with TA4F) ................................WA340
Optional Accessories
Bodypack Pouch (Black) ............................................................. WA581B
Bodypack Pouch (White) ............................................................. WA581W
3-Pin mini Lemo conversion kit........................................................WA335
Note
SHURE Incorporated http://www.shure.com
United States, Canada, Latin America, Caribbean:
5800 W. Touhy Avenue, Niles, IL 60714-4608, U.S.A.
Phone: 847-600-2000 U.S. Fax: 847-600-1212 Int'l Fax: 847-600-6446
Europe, Middle East, Africa:
Shure Europe GmbH, Phone: 49-7131-72140 Fax: 49-7131-721414
Asia, Pacific:
Shure Asia Limited, Phone: 852-2893-4290 Fax: 852-2893-4055
2
4-Pin male mini connector (TA4M)
3-Pin female mini connector (LEMO XRB.00.303)
Unbalanced, active
+5 dBu (sensitivity 0 dB)
+15 dBu (sensitivity –10 dB)
Pin 1: Ground
Pin 2: +5 VDC bias
Pin 3: Audio, 200 kΩ
Pin 4: Tied through active load (on main board)
to ground.
(On instrument adapter cable, Pin 4 floats)
Pin 1: Ground
Pin 2: +5 VDC bias
Pin 3: Audio
(8.2 kΩ between pin 2 and 3, internal to UR1M)