AOpen AX4SPE Max Online Manual page 42
Hide thumbs
Also See for AX4SPE Max:
- Manual (59 pages) ,
- Easy installation manual (8 pages) ,
- Easy installation manual (8 pages)
Table of Contents
Advertisement
A
X
4
S
P
E
M
a
x
A
X
4
S
P
E
M
a
x
If you intend to change the default setting, simply press Enter for a list of selection:
Note: Please be informed that when you are using Windows98/ME with six hard disks fully installed, Auto mode is not able to function
properly, it's just because Windows98/Me is not able to energize Enhanced Mode to detect all hard disks.
3.
Combined Mode: If you have had installed traditional IDE hard disks and Serial ATA hard disks at the same time, then you may
choose this Combined Mode. Under this mode, you may randomly choose either IDE hard disks or Serial ATA had disk as your first
boot device. But please be aware that Serial ATA will exist with IDE in a mapping way, which also means it will occupy one of the IDE
Channel and left you with one IDE Channel only.
4.
Enhanced Mode: If you are using the latest operating system (say, Windows XP, Windows.NET Server), it is highly recommended to
select Enhanced Mode. The system would be able to detect all six devices (traditional IDE x4, Serial ATA x 2) completely and functions
perfectly under this mode. But please be noted that it is defaulted with using traditional IDE as the first boot device.
Note: From our practical lab tests, we found no obvious problem or mistakes happened under Windows2000 operating system, but,
however, it is not within the regulation recommended by Intel.
5.
SATA Only: You may select this SATA Only mode if you have had installed Serial ATA hard disks only. It also allows you to select
booting sequence from Port0 (SerialATA1) or Port1 (SerialATA2).
1.
Disabled: You may choose this item if you're sure that only traditional IDE hard
disks had been installed on your system. Disabling this item may also cancel the
detection to Serial ATA hard disk during POST, which theoretically, could speed up
your boot-up timing for a little bit; however, please remember to re-adjust the
settings here if you intend to use Serial ATA hard disk later.
2.
Auto: This is the default setting upon receipt of the motherboard. Basically, if your
system functions properly, it's not necessary to change it. The system will
automatically recognize the first hard disk on IDE1 as the first boot device.
42
O
n
l
i
n
e
M
a
n
u
a
l
O
n
l
i
n
e
M
a
n
u
a
l
Advertisement
Table of Contents
