AOpen AX4SPE Max Online Manual page 121
Hide thumbs
Also See for AX4SPE Max:
- Manual (59 pages) ,
- Easy installation manual (8 pages) ,
- Easy installation manual (8 pages)
Table of Contents
Advertisement
A
X
4
S
P
E
M
a
x
A
X
4
S
P
E
M
a
x
With the Silicon Image controller already plugged in and the driver already installed. Follow the instructions to update SiI RAID driver.
1. Right click on 'My Computer' and select 'Properties'. Under the 'System Properties' section, click on 'Hardware' tab, and then on 'Device
Manager' click 'SCSI and RAID Controller' and right click 'Silicon Image Ultra-133 Medley ATA Raid Controller'.
2. Click 'Driver', 'Update Driver' and select 'Search for a suitable driver for my device [Recommended]'. Insert the driver diskette into floppy
drive. Click 'Next' and complete the driver installation.
3. System will go through the enumeration process and install the driver. At the end of the process, click 'Yes' to reboot your system when
necessary.
4. See instructions in section 4 to verify controller was installed correctly.
---------------------------------------------------------------------------------------
7) Windows 98SE and Windows ME Fresh Installation Instructions
---------------------------------------------------------------------------------------
Follow the instructions in this section if you are performing a new installation of Windows 98SE/ME and you wish to boot from a device
attached to the SiI 3112 controller.
You may start up the Windows 98SE/ME installation from CD. If either your Windows 98SE/ME CD or CD-ROM drive is not bootable, your
can start up with floppy diskettes.
1. Power off the system. Connect the hard drives to the SiI RAID controller and insert the controller into a PCI slot. Power up the system
2. Put your Windows 98SE/ME CD into the CD-ROM/DVD drive, and the Windows 98SE/ME boot diskette in the floppy drive if your system
cannot boot from the CD.
3. Follow the normal Windows 98SE/ME setup instructions to select your choice for partition and file system.
4. Wait until Windows 98SE/ME finishes installing devices, regional settings, networking settings, components, and final set of tasks, reboot
121
O
n
l
i
n
e
M
a
n
u
a
l
O
n
l
i
n
e
M
a
n
u
a
l
Advertisement
Table of Contents
