AOpen AX4SPE Max Online Manual page 122

A X 4 S P E M a x
A X 4 S P E M a x
the system.
5. After the system reboot, right click on 'My Computer' and select 'Properties'. From the 'System Properties' , select 'Device Manager', right
click on the '?PCI RAID controller' and select 'Properties' from the pop-up menu.
6. Click 'Driver','Update Driver' and select 'Automatic search for a better driver [Recommended]'. Insert the driver diskette into floppy drive.
Click 'Next' and complete the driver installation.
7. System will go through the enumeration process and install the driver. At the end of the process, click 'Yes' to reboot your system.
8. See instructions in section A to verify controller was installed correctly.
---------------------------------------------------------------------------------------------
8) First time installing SiI RAID driver with existing Windows 98SE/ME
---------------------------------------------------------------------------------------------
If you have an existing Windows 98SE/ME system and just obtained a Silicon Image SiI 3112 controller card, you need to run the update
program to install Silicon Image driver. The driver package is located in the Silicon Image driver diskette or the diskette provided by OEM
vendor.
1. Power off the system. Connect the hard drives to the SiI 3112 controller and insert the controller into a PCI slot. Power up the system.
2. During the system boot up, the Hardware Wizard will display that it found a ' PCI RAID Controller' , click ' Next' . Select ' Search for the
best driver for your device [Recommended]' and click ' Next' .
3. Check the ' Floppy disk drives' and insert the driver diskette into floppy drive. Click ' Next' .
4. System will go through the enumeration process and install the driver. At the end of the process, Click ' Finish' to complete the
installation. Reboot the system if your Windows 98SE/ME drive is connected on the SiI RAID Controller.
122
O n l i n e M a n u a l
O n l i n e M a n u a l