AOpen AX4SPE Max Online Manual page 119

A X 4 S P E M a x
A X 4 S P E M a x
2. During OS boot up, Windows 2000 will display the 'Found New Hardware Wizard'. Click 'Next'.
3. Select 'Search for a suitable driver for my device (Recommended)' and Click 'Next'.
4. Under 'Optional search locations' insure that 'Floppy disk drives' is checked.
5. Insert the diskette labeled ' Silicon Image SiI 3112 SATA Raid Driver Installation Disk' into A: and click 'Next'.
6. When the wizard indicates that it found a driver for the device click 'Next'.
7. If the 'Digital Signature Not Found' dialog appears, click 'Yes' to continue installing the driver.
8. The wizard will now copy the required files to the system and start the driver. After starting the driver the wizard will display a
completion dialog, click 'Finish' to exit the wizard.
9. See instructions in section 4 to verify controller was installed correctly.
-----------------------------------------------------------------------------------------
4) Verifying controller installation under Windows NT, 2000 and XP
-----------------------------------------------------------------------------------------
Follow the instructions in this section to verify that the controller was installed correctly.
For Windows 2000/XP
1. Right click on 'My Computer' icon, select 'Properties', left click on 'Hardware' tab, and then on 'Device Manager' button.
2. Double click on 'SCSI and RAID Controllers', If there is no yellow '! 'or' ? 'in front of 'Silicon Image SiI 3112 SATA Raid Controller', the
driver is started correctly.
3. To view information about the devices attached to the controller, use the SiICfg Utility and click on the device from the list.
For Windows NT 4.0
119
O n l i n e M a n u a l
O n l i n e M a n u a l