Router Test Setup Procedure - AOpen ISDN SOHO Router User Manual

5.12 Router Test Setup Procedure

There are three steps to the router test setup:
Connect the router to your ethernet network
Connect the router to the ISDN interface (ARCA box and Total Control Hub)
Configure the router
The following figure is used as an example to illustrate how to connect the router to various
network components and configure the router:
129.97. 35. 0
129.97. 35. 58
P C
LA N1
The labeled addresses will be used to configure the IP addresses for all the corresponding devices.
Connect all the network components as shown in the figure.
After loading up the AT command interface on your PC, which has the IP address 129.97.35.58, the
router can be configured as follows:
Type AT: to go to router command interface mode.
Configure the ethernet ip address for the router:
CLI> config int ether ip add 129.97.35.1 255.255.255.0
ISDN Router Manual V.1.1
. 1 192.168. 1. 2
192.168. 1. 1
ISDN
Router
129.97. 34. 0
129.97. 34. 1
. 100
S erver
Tot al Con trol
Hub
LA N2
39