Configure Isdn Switch Type And Directory Number; Configure General Setup - AOpen ISDN SOHO Router User Manual

5.4.4 Configure ISDN Switch Type and Directory Number

config interface isdn switch type {etsi,ntt,ni1}
Configure the switch type for an ISDN interface
Check with your local PTT to setup proper ISDN switch type otherwise the router may not
operate correctly.
etsi : European DSS1 switch (also called NET3)
ntt : Japan INS64 switch (also called NTT-KDD)
ni1 : Northern American National ISDN-1 switch
You should check the supported switch type by your router by typing ATI2 in AT command
mode.
Note: you can also use AT!W to setup the appropriate switch type in AT command mode.
config interface isdn switch spid1 <spid#1> spid2 <spid#2> dn1 <dn#1> dn2 <dn#2>
Configure the service provider id and directory number for an ISDN interface
Setup the telephone number and Service Profile Identifier (SPID) to TEL-A and TEL-B. The
spid#1 and dn#1 will be assigned to TEL-A. The spid#2 and dn#2 will be assigned to TEL-B.
The SPID is always obtained from your local PTT for service and identification purpose.
config interface isdn show
Display the current ISDN interface settings

5.5 Configure General Setup

config system hostname <hostname>
Change the top level of CLI prompt.
You can change the top level of the CLI prompt as you like by this command. The default
prompt is 'CLI'.
ISDN Router Manual V.1.1 28