Connecting/Disconnecting Isdn; Save And Delete Configuration - AOpen ISDN SOHO Router User Manual

When the firewall is turned on, in order to have NAT you must enter the command :
>config fire add divert ip from any to any via isdn

5.8 Connecting/Disconnecting ISDN

connect <username>
Start a PPP or ML-PPP connection with the username.
This is a manual method to make connection. The router will automatically extract the telephone
number associated with the username and make an outgoing call to connect with the destination
site. The PPP/ML-PPP connection will be decided by the maxchan set of the username stored in
the User Account Table. You can connect two username at the same time under PPP
connection for each user. Therefore the router can connect two different destinations
simultaneously.
disconnect <username>
Stop a PPP or ML-PPP connection of the current user.
When disconnect one destination link, you need to specify the corresponding username.
Because the router may connect two separated link with two username, each under PPP
connection. Therefore you must specify which one to be disconnected.

5.9 Save and Delete Configuration

config save
Save the configuration from memory to flash. All the changes up to this point are saved onto
EPROM and will take effect at the next reboot.
delete all
Delete all of the current configuration. Only take effect after resetting the power of the router.
flash { list, delete }
Display/erase the files on the flash which consist of the boot image and the configuration
ISDN Router Manual V.1.1 35